Advances in Engineering Fluid Mechanics: Multiphase Reactor by Nicholas P. Cheremisinoff (Eds.)

  • admin
  • February 26, 2017
  • Fluid Dynamics
  • Comments Off on Advances in Engineering Fluid Mechanics: Multiphase Reactor by Nicholas P. Cheremisinoff (Eds.)

By Nicholas P. Cheremisinoff (Eds.)

Content material:
Contributors to this volume

, Pages viii-x
About the editor

, Page xi
Preface

, Page xii, Nicholas P. Cheremisinoff
Chapter 1 - The viscosity of liquid hydrocarbons and their mixtures

, Pages 1-23, Stanley I. Sandler, Hasan Orbey
Chapter 2 - Experimental reports for characterization of combining mechanisms

, Pages 25-47, Jin Kuk Kim
Chapter three - actual modeling of axial blending in slugging gas-liquid columns

, Pages 49-65, J.R.F. Guedes de Carvalho, J.B.L.M. Campos, J.A.S. Teixeira
Chapter four - Numerical resolution of the permeation, sorption, and desorption cost curves incorporating the dual-mode sorption and delivery model

, Pages 67-78, Keio Toi
Chapter five - Kinematic viscosity and viscous stream in binary combos containing ethane-1,2-diol

, Pages 79-104, Lorenzo Tassi
Chapter 6 - response of a continuing blend in a effervescent fluidized bed

, Pages 105-117, R. Aris
Chapter 7 - Fluid dynamics of coarse dispersions

, Pages 119-166, Y.A. Buyevich, S.K. Kapbasov
Chapter eight - Combustion of unmarried coal debris in turbulent fluidized beds

, Pages 167-191, Prabir Kumar Halder
Chapter nine - stream of solids and slurries in rotary drums

, Pages 193-253, H.A. Nasr-El-Din, A. Afacan, J.H. Masliyah
Chapter 10 - fuel section hydrodynamics in circulating fluidized mattress risers

, Pages 255-296, Gregory S. endurance, Jamal Chaouki, Franco Berruti
Chapter eleven - Boundary stipulations required for the CFD simulation of flows in stirred tanks

, Pages 297-316, Suzanne M. Kresta
Chapter 12 - position of interfacial shear modelling in predicting balance of stratified two-phase flow

, Pages 317-378, N. Brauner, D. Moalem Maron
Chapter thirteen - Water stream via helical coils in turbulent condition

, Pages 379-403, Sudip Kumar Das
Chapter 14 - Modeling coalescence of bubble clusters emerging freely in low-viscosity liquids

, Pages 405-429, C.W. Stewart
Chapter 15 - Oxygen move in non-newtonian fluids stirred with a helical ribbon screw impeller

, Pages 431-453, A. Tecante, E. Brito de l. a. Fuente, L. Choplin, P.A. Tanguy
Chapter sixteen - Modeling of the hydrodynamic habit of hugely viscous fluids in stirred tanks built with two-blade impellers

, Pages 455-485, Catherine Xuereb, Mohammed Abid, Bertrand Joël
Chapter 17 - Non-newtonian liquid move via globe and gate valves

, Pages 487-505, Sudip Kumar Das
Chapter 18 - comparability of numerical and experimental rheological info of homogeneous non-newtonian suspensions

, Pages 507-524, V. Nassehi
Chapter 19 - focus forcing of isothermal plug-flow reactors for autocatalytic reactions

, Pages 525-538, M. Chidambaram
Chapter 20 - Non-newtonian results in bubble columns

, Pages 539-570, R.P. Chhabra, U.K. Ghosh, Y. Kawase, S.N. Upadhyay
Chapter 21 - stories in supported titanium catalyst method utilizing magnesium dichloride-alcohol adduct

, Pages 571-581, V.K. Gupta, Shashikant, M. Ravindranathan
Chapter 22 - Plasticizing polyesters of dimer acids and 1,4-butanediol

, Pages 583-597, U.D.N. Bajpai, Nivedita
Chapter 23 - Viscoelastic houses of version silicone networks with pendant chains

, Pages 599-614, M.A. Villar, E.M. Vallés
Chapter 24 - Rheology of water-soluble polymers used for better oil recovery

, Pages 615-668, H.A. Nasr-El-Din, K.C. Taylor
Chapter 25 - Relation of rheological houses of UV-cured movies with glass transition temperatures according to fox equation

, Pages 669-681, M. Azam Ali, M.A. Kahn, K.M. Irdriss Ali
Chapter 26 - Prediction and calculation of the shear creep habit of amorphous polymers lower than revolutionary actual aging

, Pages 683-709, R.O.E. Greiner, J. Kaschta
Chapter 27 - Die extrusion habit of carbon black-filled block copolymer thermoplastic elastomers

, Pages 711-736, Jin Kuk Kim, Min Hyeon Han
Chapter 28 - Polysulfides

, Pages 737-746, C.P. Tsonis
Chapter 29 - homes and functions of thermoplastic polyurethane blends

, Pages 747-761, M. Yue, K.S. Chian
Index

, Pages 763-772

Show description

Read Online or Download Advances in Engineering Fluid Mechanics: Multiphase Reactor and Polymerization System Hydrodynamics. Advances in Engineering Fluid Mechanics Series PDF

Best fluid dynamics books

Applied Biofluid Mechanics

Enhance Your clutch of Fluid Mechanics within the Human Circulatory System_and improve greater scientific units utilized Biofluid Mechanics contains a strong seize of the position of fluid mechanics within the human circulatory approach that may assist in the learn and layout of recent scientific tools, gear, and strategies.

Analisi Dimensionale e Modellistica Fisica: Principi e applicazioni alle Scienze Ingegneristiche

L. a. razionalizzazione delle scienze ha avuto un grande impulso con l’avvento e il consolidarsi dei concetti dell’Analisi Dimensionale, accanto alla quale si ? sviluppata los angeles modellistica fisica. Al pace in cui gli elaboratori non erano disponibili o non erano accessibili, l. a. modellistica fisica rimaneva l’unico strumento in line with affrontare e risolvere numerosi problemi di Ingegneria; non a caso l. a. maggior parte delle pubblicazioni scientifiche nel settore ?

Stromungslehre fur den Maschinenbau: Technik und Beispiele

Diese anwendungsbezogene Vertiefung der Themen aus den Grundlagen der Strömunglehre wendet sich an Ingenieure und Studenten der Ingenieurwissenschaften, Physik und anwendungsorientierten Mathematik. Die zahlreichen Praxisbeispiele sind hilfreich für Hersteller und Anwender aus vorwiegend strömungstechnischer Industrie.

Additional resources for Advances in Engineering Fluid Mechanics: Multiphase Reactor and Polymerization System Hydrodynamics. Advances in Engineering Fluid Mechanics Series

Sample text

He observed that, as the angle between the column axis and the vertical direction is increased, the intensity of dispersion increases, at first very markedly (angles up to 3°) and then more gradually (angles between 3° and 60°). He also observed that in the inclined columns a higher degree of dispersion is obtained if the slugs are longer, and this is at variance with the observations in vertical columns. Visual observations and the results of a study on mixing suggested that the recirculating wake behind slugs rising in an inclined column is much longer than that observed behind slugs rising in the same column aligned vertically.

Polym. , 7, p. 427 (1987). 3. , Rubber Age, 97, p. 82 (1965). Experimental Studies for Characterization of Mixing Mechanisms 47 4. , Rubber Chem. , 56, p. 233(1983). 5. , Rubber Chem. , 29 p. 1,303 (1956). 6. , Applied Science Publishers, New York, 1983. 7. D. Dissertation, University of Akron (1986). 8. , Nihon Reorogi Gakkaiski, 7, p. 20 (1979). 9. C. , Appl Optics, 9, p. 113 (1970). 10. V. , J. Appl. Polym. ScL, 14, p. 2,785 (1970). 11. N. , J. Coll. Inter. ScL, 63, p. 297 (1978). 12. , Kyu, T.

And Rotz, C. , SPEANTEC Tech. Paper, 27, p. 223 (1981). 18. , Pro. Roy. Soc. (London), A84, p. 25 (1811). 19. , Recent Researches in Electricity and Magnetium," Oxford University Press, London (1893). 20. , Ann. , 46, p. 809 (1905). 21. , Ann. , 12, p. 161 (1939). 22. Min, K. , Rubber Chem. , 58, p. 1,024 (1985). 23. K. , Nihon Reorogi Gakkaishi, 17, p. 203 (1989). 24. L. , J. AppL of Polym. , 44, p. 59 (1989). 25. D. Dissertation, University of Akron (1989). 26. , J. of AppL Polym. , 50, p. 145 (1992).

Download PDF sample

Rated 4.75 of 5 – based on 5 votes